Wilwood Tandem Master Cylinder (TM1) Manuel d'utilisateur télécharger pdf

5/8” TM1 TANDEM MASTER CYLINDER

PART NUMBER: 260-11097

4700 Calle Bolero • Camarillo, CA 93012 Phone 805 / 388-1188 • www.wilwood.com

Installation of this component should ONLY be performed by persons experienced in the installation and proper operation of disc

brake systems. Before installation of the Wilwood TM1 remote tandem master cylinder, read this document carefully to familiarize

yourself with the procedure before beginning. Also, for your reference (on the following pages) is a master cylinder dimensional

and remote setup diagram.

Reservoir Selection:

The reservoirs cannot be mounted directly onto the master cylinder body. The reservoirs must mount in a remote location using

the remote mounting brackets (connected by the hoses included with P/N 260-11098). Always use the clamps provided with the

reservoirs and remote inlet adapters. Do not over tighten.

Mounting Location:

Master cylinder should be firmly mounted to appropriate pedal assembly and kept away from heat sources. Use small hose clamps

to secure hose when remote reservoirs are used. Check to verify that the full stroke of pushrod is unimpeded when depressing

brake pedal and that pushrod is allowed to fully retract when brake pedal is released.

DS-741 REV DATE: 06-09-10

NOTE: Some cleaners may stain or remove the finish on brake system components. Test the cleaner on a hidden

portion of the component before general use.

WARNING

IT IS THE RESPONSIBILITY OF THE PERSON INSTALLING ANY BRAKE COMPONENT OR KIT TO DETERMINE THE SUITABILITY OF THE

COMPONENT OR KIT FOR THAT PARTICULAR APPLICATION. IF YOU ARE NOT SURE HOW TO SAFELY USE THIS BRAKE COMPONENT OR

KIT, YOU SHOULD NOT INSTALL OR USE IT. DO NOT ASSUME ANYTHING. IMPROPERLY INSTALLED OR MAINTAINED BRAKES ARE

DANGEROUS. IF YOU ARE NOT SURE, GET HELP OR RETURN THE PRODUCT. YOU MAY OBTAIN ADDITIONAL INFORMATION AND

TECHNICAL SUPPORT BY CALLING WILWOOD AT (805) 388-1188, OR VISIT OUR WEB SITE AT WWW.WILWOOD.COM. USE OF WILWOOD

TECHNICAL SUPPORT DOES NOT GUARANTEE PROPER INSTALLATION. YOU, OR THE PERSON WHO DOES THE INSTALLATION MUST

KNOW HOW TO PROPERLY USE THIS PRODUCT. IT IS NOT POSSIBLE OVER THE PHONE TO UNDERSTAND OR FORESEE ALL THE ISSUES

THAT MIGHT ARISE IN YOUR INSTALLATION.

RACING EQUIPMENT AND BRAKES MUST BE MAINTAINED AND SHOULD BE CHECKED REGULARLY FOR FATIGUE, DAMAGE, AND WEAR.

WARNING

DO NOT OPERATE ANY VEHICLE ON UNTESTED BRAKES!

SEE MINIMUM TEST PROCEDURE WITHIN

ALWAYS UTILIZE SAFETY RESTRAINT SYSTEMS AND ALL OTHER AVAILABLE SAFETY EQUIPMENT WHILE OPERATING THE VEHICLE

IMPORTANT • READ THE DISCLAIMER OF WARRANTY INCLUDED IN THE KIT

1 2 3

5/8” TM1 TANDEM MASTER CYLINDERPART NUMBER: 260-110974700 Calle Bolero • Camarillo, CA 93012 Phone 805 / 388-1188 • www.wilwood.comInstal

Page 2

Bleeding Instructions:Master cylinder should be bled while mounted to the brake pedal assembly. Pedal must allow full travel (stroke) of master cylin

Wilwood Disc Brakes • Camarillo, CA 93012 Phone 805 / 388-1188 • www.wilwood.comE-mail Technical Assistance: [email protected](59,9

Pas de commentaire

Wilwood Tandem Master Cylinder (TM1) Manuel d'utilisateur